67
Chapter 6
Customize Your Network Settings
4. When the WPS LED is on, the client device has successfully connected to the mesh
device.
Method 2: Use the “Connect” button on the web management page
Use this method if your client device has a WPS button.
1. Visit http://tplinkwifi.net or http://192.168.88.1, and log in with the password you
set for the mesh device.
2. Go to Advanced > Wireless > WPS page.
3. Click Connect on the page.
4. Press the WPS button of the client device directly.
5. The WPS LED of the mesh device flashes for about 2 minutes during the WPS
process.
6. When the WPS LED is on, the client device has successfully connected to the mesh
device.
Method 3: Enter the mesh device’s PIN on your client device
Use this method if your client device asks for the mesh device’s PIN.
1. Visit http://tplinkwifi.net or http://192.168.88.1, and log in with the password you
set for the mesh device.
2. Go to Advanced > Wireless > WPS, and enable Mesh Device’s PIN.
3. Take a note of the current PIN of the mesh device. You can also click the Generate
button to get a new PIN.
To Next Page
Loading...
