68
Chapter 6
Customize Your Network Settings
4. Enter the mesh device’s PIN on the client device. (The default PIN is also printed on
the label of the mesh device.)
5. The WPS LED flashes for about 2 minutes during the WPS process.
6. When the WPS LED is on, the client device has successfully connected to the mesh
device.
Note:
1. The WPS LED on the mesh device will light on for five minutes if the device has been successfully added to the
network.
2. The WPS function cannot be configured if the wireless function of the mesh device is disabled. Please make sure the
wireless function is enabled before configuring WPS.
Method 4: Enter the client device’s PIN on the mesh device
1. Visit http://tplinkwifi.net or http://192.168.88.1, and log in with the password you
set for the mesh device.
2. Go to Advanced > Wireless > WPS, and click PIN Number.
3. Enter the Client’s PIN.
4. Then click the Connect button.
5. Device has been added successfully! or the similar information will appear on the
web page, which means the client device has successfully connected to the mesh
device.
To Next Page
Loading...
