TP-Link NC260 - Page 33

NC260
31
 Username: Enter the username that is used to log in to your FTP server.
 Password: Enter the password that is used to log in to your FTP server.
 Path: Enter the path to the destination on the FTP server.
 Passive Mode: Enabling passive mode may help you reach your FTP server if your camera
is behind a router protected by a firewall.
To set up a FTP to receive notification, follow the steps below:
1. Enter an IP address or domain of your FTP server, e.g. 192.168.1.168
2. Remain the FTP port number as the default value: 21.
3. Enter your username to log in to the FTP server, e.g. test.
4. Enter your password to log in to the FTP server.
5. Enter the path to the destination on the FTP server, e.g. /test
6. Enable Passive Mode.
7. Click Save to save and enable the settings.
Click Test, and a test JPEG snapshot will be sent to the specified FTP server to check whether
your settings are correct.
If the settings are tested correct, click OK.
If the settings are tested incorrect, check your network and FTP settings and try again later.
Email
Select Email, and you can configure your camera to send snapshots to specified email
addresses on the following screen: