TP-Link NC260 - Page 7

NC260
5
 WPS/RESET Button: The switch for the WPS and Reset function. To use the WPS function,
press it for about 2 seconds. To use the Reset function, press and hold for more than 5
seconds.
• Used as the WPS button:
If your wireless router supports WPS (Wi-Fi Protected Setup), you can connect the
camera to your Wi-Fi network using WPS. Press the WPS or QSS button on your
router. Within 2 minutes, press the WPS/RESET button on the camera for about 2
seconds, then the LED above this button will start flashing quickly. When this LED
becomes solid on, the WPS is successful.
• Used as the RESET button:
With the camera powered on, press and hold the WPS/ RESET button (for more than 5
seconds) until the System LED turns off. Then release the button and wait the camera
to reset to its factory default settings.
 WPS LED:
Status
Indication
Flashing Green
The camera starts booting up.
The camera is connecting to a network by WPS function.
Off
The camera has boot up.
The camera failed to be added to a network by WPS function.
Solid Green
The camera has been successfully added to a network by WPS
function. This process will last in the first two minutes.