8
Chapter 2
Initial Use
SSID:TP-Link_XXXX
SSID:TP-Link_XXXX_5G
Wireless Password:XXXXXXXX
SSID:TP-LINK_XXXX
SSID:TP-LINK_XXXX_5G
Wireless Password:XXXXXXXX
Done!
Now enjoy the internet with the SSIDs and password printed on the label!
Method 2: Pairing
1. Connect the powerline adapter to an available LAN port of the router.
2. Plug the powerline adapter into a wall socket.
3. Plug the powerline extender into a wall socket near the adapter.
4. Pair the powerline devices.
a . Press the Pair button of the powerline adapter for 1 second. The Powerline LED
should start blinking green.
Note: If the Powerline LED does not blink, press the Pair button again.
b . (Within two minutes) press the Pair button of the powerline extender for 1 second.
The Power LED should start blinking. When the extender’s Powerline LED
turns
solid green, the pairing process is done!
Within 2 minutes
Adapter
Extender
Blinking
Green
Blinking Green
Solid Green
5. Relocate the new extender to the Wi-Fi “dead” zone. Connect your devices to the
internet using the SSIDs (network name) and password printed on the label at the
side of the extender.
To Next Page
Loading...
