TP-Link PGW2440 - Upgrade the Firmware

28
Chapter 3
3. Click BROWSE to locate the backup configuration file stored on your computer,
and click RESTORE. The configuration file is config.bin.
4. Wait a few minutes for the restoring and rebooting.
Note: During the restoring process, do not turn off or reset the extender.
• To reset the extender to factory default settings:
1. Connect to the powerline extender wirelessly. Visit http://tplinkplc.net, and log
in with the password you set for the extender.
2. Go to System > Backup & Restore > Factory Default Restore page.
3. Click FACTORY RESTORE to reset the extender.
4. Wait a few minutes for the resetting and rebooting.
Note:
1. During the resetting process, do not turn off the extender.
2. We strongly recommend you back up the current configuration settings before resetting the extender.
3. 11. 4. Upgrade the Firmware
TP-Link is dedicated to improving and richening the product features, giving
you a better network experience. We will release the latest firmware at TP-Link
official website, you can download the latest firmware file from our website:
www.tp-link.com and upgrade the firmware to the latest version.
1. Connect to the powerline extender wirelessly. Visit http://tplinkplc.net, and log
in with the username and password you set for the extender.
2. Go to System > Firmware Upgrade page and confirm the Hardware Version.