TP-Link RE330 - Setting Up as an Access Point

37
Chapter 6 Use Your Extender as an Access Point
The extender can work as an access point, transforming your existing wired network to
a wireless one.
6. 1. Set Up the Extender as an Access Point
1. Visit http://tplinkrepeater.net, and log in with your TP-Link ID or the password you set
for the extender.
2. Click Change Mode in the top right corner of the page. Select Access Point Mode and
click OK. The extender will reboot and switch to Access Point mode.
3. After rebooting, connect to the extender’s network TP-Link_Extender or TP-Link_
Extender_5GHz.
4. Visit http://tplinkrepeater.net, and log in with your TP-Link ID or the password you set
for the extender.
5. Go to Settings > Quick Setup to configure your extender.
1 ) Customize your wireless SSID and password and click NEXT.
Downloaded from ManualsNet.com search engine