38
2. If you connect the IP Camera with your computer directly, the default network domain of camera is
192.168.1.xx.
7.3.2 PPPoE (Point-to-Point Protocol over Ethernet)
If your ISP provides Dynamic IP with authentication by username and password, type all PPPoE
information in this part. When you use the PPPoE function, you need to turn on the DDNS or IP
Notification function at same time.
¾ IP Address: The IP address obtained at the PPPoE connecting with network.
¾ User ID: Enter the user ID for authentication necessary for PPPoE connections. Type it up to 64
characters.
¾ Password: Enter the password for authentication necessary for PPPoE connections. Type it up to
32 characters.
¾ Re-type Password: Re-type the password to confirm.
¾ Obtain DNS server address automatically: Select this to obtain the address of DNS server
automatically.
¾ Use the following DNS server address: Select this when you set the fixed address as the IP
address of DNS server.
z Primary DNS server: Enter the IP address of the primary DNS server.
z Secondary DNS server: Enter the IP address of the secondary DNS server.
)
Note:
1. PPPoE (Point-to-Point Protocol over Ethernet): PPPoE is a network protocol for encapsulating
Point-to-Point Protocol frames insider Ethernet frames. PPPoE connection is used mainly with
ADSL service where individual users connect to the ADSL transceiver (modem) over Ethernet work.
It also widely used in XDSL. (digital affiliate line such as ADSL, VDSL or SDSL)
2. The IP Camera needs to be rebooted after it finishes changing the network completely.
3. The IP Camera with Intelligent IP Installer can’t be found after PPPoE is active, but you can get the
IP address of the camera by IP Notification function. For more details, please refer to Section 7.3.6
.
4. If the IP Notification function is not configured to report the IP address of the camera, you can reset
the camera to its factory default settings by pressing the Reset button. Then the camera can be
found by Intelligent IP Installer.
To Next Page
Loading...
