68
9 Message: message will show up in the form of Message = PTZ down. If your target device
didn’t support the parameter of message, you can’t see the message. So you can just take
the message as a note. For example: PTZ down.
z Alarm Input: Select the connected alarm.
9 Alarm input1: The external sensor which is connected to sensor input1 of the alarm input.
)
Note:
You can set the alarm input function at Alarm Input page. (Please go to “Setting → Advanced →
Alarm Input → Setting”. For more details, please refer to Section 8.9
.)
9 Parameter: the parameter of CGI (defined in URL of HTTP→General) is from your target
device. For example, move=down.
9 Message: message will show up in the form of Message = PTZ down. If your target device
didn’t support the parameter of message, you can’t see the message. So you can just take
the message as a note. For example: PTZ down.
¾ Effective period: Set the period when the periodical sending is effective.
z Always: The periodical sending is always effective.
z Schedule: You can specify the period when the periodical sending is effective in the Schedule
setting in the other section.
To Next Page
Loading...
