TL-WA601G 108M Wireless Access Point User Guide
20
3.4.4 MAC Filtering
The Wireless MAC Filtering for wireless networks is set on this page, Figure 3-12:
Figure 3-12 Wireless MAC address Filtering
The Wireless MAC Address Filtering feature allows you to control wireless stations accessing the
AP, which depend on the station's MAC addresses.
¾ MAC Address - The wireless station's MAC address that you want to access.
¾ Description - A simple description of the wireless station.
¾ Privilege - Allow means allowing the station to access the AP. Deny means denying the
station to access the AP. 64-bit, or 128-bit, or 152-bit means assigning a unique WEP key to
access the AP.
¾ WEP Key - Specify a unique WEP key (in Hexadecimal format) to access the AP.
¾ Status - The status of this entry, either Enabled or Disabled.
To disable the Wireless MAC Address Filters feature, keep the default setting, Disable.
To set up an entry, click Enable, and follow these instructions:
First, you must decide whether the unspecified wireless stations can or cannot access the AP. If
you desire that the unspecified wireless stations can access the AP, please select the radio button
Allow the stations not specified by any enabled entries in the list to access, otherwise,
select the radio button Deny the stations not specified by any enabled entries in the list to
access.
To Add a Wireless MAC Address filtering entry, click the Add New… button. The “Add or Modify
Wireless MAC Address Filtering entry" page will appear, shown in Figure 3-13:
To Next Page
Loading...
