TL-WA601G 108M Wireless Access Point User Guide
29
Figure 3-22 Restore Factory Default
Click the Restore button to reset all configuration settings to their default values.
• The default User Name: admin
• The default Password: admin
• The default IP Address: 192.168.1.1
• The default Subnet Mask: 255.255.255.0
)
Note:
Any settings you have saved will be lost when the default settings are restored.
3.7.3 Reboot
This page (shown in Figure 3-23) allows you to reboot the AP.
Figure 3-23 Reboot the AP
Click the Reboot button to reboot the AP.
Some settings of the AP will take effect only after rebooting, which include:
• Change LAN IP Address. (System will reboot automatically)
• MAC Clone (system will reboot automatically)
• DHCP service function.
• Static address assignment of DHCP server.
• Upgrade the firmware of the AP (system will reboot automatically).
• Restore the AP's settings to factory default (system will reboot automatically).
3.7.4 Password
This page (shown in Figure 3-24) allows you to change the factory default user name and
password of the AP.
To Next Page
Loading...
