-16-
Select Dynamic IP if none of the above parameters are provided. Then you just need to enter
server IP address or domain name provided by your ISP.
4. Click Next to continue, the Wireless settings page will appear as shown in Figure 3-12.
Figure 3-12 Quick Setup – Wireless
Wireless Radio - Enable or disable the wireless radio by choosing from the drop-down
list.
Wireless Network Name - Enter a value of up to 32 characters. The same name of
SSID (Service Set Identification) must be assigned to all wireless devices in your
network. Considering your wireless network security, the default SSID is set to be
TP-LINK_XXXX (XXXX indicates the last unique four numbers of each router’s MAC
address). This value is case-sensitive. For example, TEST is NOT the same as test.
Disable Security - The wireless security function can be enabled or disabled. If disabled,
the wireless stations will be able to connect the router without encryption. It is strongly
recommended that you choose one of following options to enable security.
WPA-PSK/WPA2-PSK - You can enter ASCII or Hexadecimal characters.
To Next Page
Loading...
