TP-Link TL-WR1043ND - Guest Network Setup

TL-WR1043ND
450Mbps Wireless N Gigabit Router
-43-
4.7 Guest Network
Figure 4-27 The Guest Network menu
There are two submenus under the Guest Network menu (shown in Figure 4-27): Wireless
Settings and Storage Sharing.
4.7.1 Wireless Settings
Choose menu “Guest Network → Wireless Settings”, you can configure the Guest Network
Wireless Settings on the page as shown in Figure 4-28.
Figure 4-28 Guest Network Wireless Settings
 Allow Guest To Access My Local Network - If enabled, guests can communicate with
hosts.
 Enable Guest Network Bandwidth Control - If enabled, the Guest Network Bandwidth
Control rules will take effect.
 Egress Bandwidth For Guest Network - The upload speed through the WAN port for Guest
Network.
 Ingress Bandwidth For Guest Network - The download speed through the WAN port for
Guest Network.
 Guest Network – Click to enable or disable the Guest Network function here.
 Network Name - Enter a value of up to 32 characters. The same Name (SSID) must be
assigned to all wireless devices in your Guest Network.