-69- 
use the password to browse the built-in web pages to perform Administrator tasks while all the 
others will be blocked.   
After click the Add button, your PC's MAC Address will be placed in the list above. 
Click the Save button to save your settings.   
 Note: 
If your PC is blocked but you want to access the router again, use a pin to press and hold the 
Reset Button (hole) on the back panel for about 5 seconds to reset the router’s factory defaults 
on the Router’s Web-Based Utility. 
4.12.4  Remote Management 
Choose menu “Security  →  Remote Management”, and  then you can configure  the  Remote 
Management function in the screen as shown in Figure 4-64. This feature allows you to manage 
your router from a remote location via the Internet. 
 
Figure 4-64 Remote Management 
  Web Management Port - Web browser access normally uses the standard HTTP service 
port 80. This router's default remote management web port number is 80. For greater security, 
you can change the remote management web port to a custom port by entering that number 
in the box provided. Choose a number between 1 and 65534 but do not use the number of 
any common service port.   
  Remote Management IP Address - This is the current address you will use when accessing 
your router from the Internet. This function is disabled when the IP address is set to the 
default value of 0.0.0.0. To enable this function change 0.0.0.0 to a valid IP address. If set to 
255.255.255.255, then all the hosts can access the router from internet.   
 Note: 
1.  To access the router, you should type your router's WAN  IP address into your browser's 
address (in IE) or Location (in Navigator) box, followed by a colon and  the custom port 
number. For example, if your router's WAN address is 202.96.12.8, and the port number 
used  is  8080,  please  enter  http://202.96.12.8:8080  in  your  browser.  Later,  you  may  be 
asked for the router's password. After successfully entering the username and password, 
you will be able to access the router's web-based utility. 
2.  Be sure to change the router's default password to a very secure password.