-44-
Wireless Security - You can configure the security of Guest Network here.
Access Time - During this time the wireless stations could accessing the AP.
Note:
The range of bandwidth for Guest Network is calculated according to the setting of Bandwidth
Control on the page “Bandwidth Control->Control Settings”.
4.7.2 Storage Sharing
You can configure Guest Network Storage Sharing on this page.
Follow the instructions below to set up your Guest Network Storage Sharing:
1. Plug an external USB hard disk drive or USB flash drive into this Router.
2. Make sure the Service Status on the page USB Setings->Storage Sharing is Started.
3. Make sure the Access shared storage with password on the page USB Setings->Storage
Sharing is enable.
4. Click the Start button to start the Guest Network Storage Sharing.
5. Click the Add New Folder to Share button to specify a folder to share for the guests.
Figure 4-29 Guest Network Storage Sharing
On this page, when a share folder is added, you can view its display name, volume partition,
folder path and you can delete the share folder by click delete button.
There is one default user account that can access the Guest Network Storage Sharing, you can
click Modify to change the password of the account.
To Next Page
Loading...
