-51-
Figure 4-40 FTP Server Configuration
Server Status - Indicates the FTP Server’s current status, started or stopped. You can click
the Start button to start the FTP Server and click the Stop button to stop it.
Internet Access – Indicates the current status of Internet Access. Choose Enable to enable
the Internet Access and choose Disable to disable it.
Service Port - The numbers of External Service Ports.
Internet address - Displays the WAN IP address of this router, so that others can access
FTP through this address. If WAN type is PPPOE/PPTP/L2TP, there would be two
connections. Therefore, users can access FTP Server via two connections. Users in a
private LAN can access FTP Server via Public Address while internet users can access
FTP Server via Internet Address.
To set up your FTP Server, please follow the instructions below:
1. Plug an external USB hard disk drive or USB flash drive into this router, and then the screen
will appear as shown in Figure 4-41.
Figure 4-41 FTP Server Configuration
To Next Page
Loading...
