TQ Aviation KTX2.0300
EASA.AP445 MAN
KTX2.A-MAN.0202.en.docx Page 41 of 49
© TQ-Systems GmbH. All information contained in this documents have to be treated strictly confidential. The transfer of presentations and know-how to third parties
requires the prior written consent of TQ-Systems GmbH.
Connect the static air connection on the back of the transponder to the static port and
ensure a tight connection with a suitable hose clamp.
5.1.5. Interface
A GPS source can be connected to the serial interface (RS232) providing GPS position
data (Extended Squitter) for use of ADS-B out.
Requirements:
• Required GPS hardware:
o NexNav Mini (Part-No. 21.000) which turns the units into FAA 2020 man-
date compliant device as required for TC’d aircraft.
or
o Standard NMEA0183 RMC data stream including the RMC-sub-format
(4800/9600/38400 Baud).
• GPS hardware needs to be connected to pins 2 and 13. Power supply needs to
be provided separately considering the required operating voltage for the GPS
hardware.
Note:
For Connection to the NexNav Mini, a proprietary cable is available from TQ. Please
contact you dealer for more information.
If a standard NMEA0183 WAAS GPS source is sufficient for your aircraft (LSA, Ex-
perimental, Ultralight etc.) you should consider recommended brands by TQ to avoid
incompatibilities or malfunctions.
The WAAS GPS hardware used needs to be selected in the setup menu (see chap.
3.1.4.4).
To Next Page
Loading...
Need help?
General
