TR 900 - User Instructions: Filling Bathtub (TR 900); TR 900 Filling Procedure; TR 900 Temperature Adjustment; TR 900 Temperature Warning

Hygiene Equipment
Designed for People
24
User instructions
TR 900/-SS, -C, CW - How to fill the bathtub with water:
- Turn the overflow valve knob to close the drain plug.
- Start filling the tub with water by open the tub filling valve (turn counterclockwise).
- The temperature shown on the digital thermometer is the tub filling temperature.
- Adjust the outlet water temperature by turning the temperature knob on the bathtub panel.
Maximum outlet temperature from the thermostatic mixer is factory pre-set to 43°C.
- Close the tub filling valve when you have reached a suitable water level (turn the knob clockwise).
- Always check the water temperature physically, by hand or with a thermometer during the filling
process to ensure that the thermostatic mixer is working properly.
- Empty the tub by turning the overflow valve counterclockwise to open the drain plug.
Tub filling valve
Digital thermometer
Temperature adjustment knob
Warning
Always check the water temperature by hand or a bath thermometer before lowering the
patient into the bath. This to prevent patients from being scalded or shocked by hot or cold
water.