TR 900 - Cleaning Instructions: Whirlpool System; Whirlpool System Cleaning Procedure; Whirlpool Jet and Inlet Cleaning; Flushing Whirlpool System

Hygiene Equipment
Designed for People
48
Cleaning instructions
All TR 900
Cleaning the Whirlpool system:
- Make sure that the Whirlpool jet (21) is fully open. If necessary, turn the disc around the Whirlpool
jet counterclockwise to open.
- Remove the Whirlpool inlet safety screen (23) by turning it counterclockwise.
- Remove the Cleaning handle (15) from the Yellow Cleaning hose and connect the Cleaning
adapter (19) to the Cleaning hose. The Cleaning hose is equipped with a Snap On/Snap Off
connector to ease the replacement.
- Place the Cleaning adapter (19) into the Whirlpool inlet (24) and hold it in place during the
Cleaning process.
- Open the Cleaning safety valve with the key or and start cleaning the Whirlpool system. Cleaning
detergent will come out from the Whirlpool jet.
- Turn the cleaning off by closing the Cleaning safety valve (13) with the safety key (turn clockwise).
- Make the same procedure with the Shower hose, disconnect the shower handle, and connect the
Cleaning adapter.
- Place the Cleaning adapter in the Whirlpool inlet and flush the Whirlpool system with fresh water.