TR 900 - Cleaning Instructions: Whirlpool Jet and Screen; Whirlpool Jet Cleaning Procedure; Whirlpool Inlet Safety Screen Cleaning; Whirlpool Operational Warnings

Hygiene Equipment
Designed for People
49
Cleaning instructions
All TR 900
Cleaning the Whirlpool Jet:
- Turn the Whirlpool jet housing (not the disc) 90°counterclockwise or until you hear a click and pull
the Whirlpool jet right out.
- Split the two- part Whirlpool jet by pressing the two hooks together and pull the jet apart.
- Clean the Whirlpool jet parts and inside the housing (21).
Cleaning the Whirlpool inlet safety screen:
- Unscrew the Whirlpool inlet safety screen (23) by turn it counterclockwise.
- Clean the Whirlpool inlet safety screen (23) and reassemble it after
cleaning.
Whirlpool jet
Warning
Only use the Whirlpool pump when the tub is filled with water. Never use the Whirlpool
pump if the tub is empty or is the water level is below the Whirlpool jet.
This will damage the Whirlpool pump.
Warning
Never use the Whirlpool if the Whirlpool inlet safety screen is not in place.
Warning
Avoid skin or eye contact with detergent, which is highly corrosive. If contact is made,
immediately rinse with excess water. If irritation occurs, consult a medical doctor.