Tracker Off-Road 800SX - Page 109

107
MOD587
2. Install the two cap screws securing the thermostat
housing and tighten to 15 ft-lb (20 N-m).
MOD551C
3. Install the coolant hose to the thermostat housing;
then pour the recommended coolant into the coolant
reservoir; then bleed the system (see Bleeding Cool-
ing System in this section).
MOD551B
COOLING FAN
Removing
1. Disconnect the radiator fan electrical connection.
MOD474
2. Remove the four cap screws securing the fan to the
radiator fan bracket; then remove the fan from the
radiator.
MOD477
Installing

NOTE: The fan wiring must be in the upper left
position.
1. Position the fan assembly to the radiator; then install
the four cap screws securing the fan to the radiator
fan bracket.
MOD477
2. Connect the radiator fan electrical connection.