36
MOD196
2. Turn the left-side and right-side tie rods (C) in equal
increments to achieve the proper toe-out; then
tighten the jam nuts securely.
3. Check steering for free operation (full-left/full-
right).
Hood
REMOVING
1. Open the hood by turning the two 1/4-turn locks at
the rear of the hood.
MOD008A
2. Remove the hood assembly.
CLEANING AND INSPECTING
1. Clean all hood components with soap and water.
2. Inspect the hood for cracks.
3. Inspect for any missing decals.
INSTALLING
Place the hood into position on the vehicle making sure
the front tabs are in place; then secure the hood with the
1/4-turn locks.
MOD044A
Upper Hood
REMOVING
1. Remove the hood; then remove the mid/upper dash-
board; then the cap screws indicated
MOD044F
2. Remove the cap screws located next to each cup
holder; then the cap screws in the middle; then
remove mid/upper dash.
MOD251
CAUTION
Always use a wrench to hold the tie rod ends when
loosening or tightening the jam nuts or damage to
the boots could occur.
To Next Page
Loading...
