39
Operating the 3D printer
7.4 Preparing your print bed
We recommend you clean the plate with a spatula if printing remains are there.
After this, clean the plate with some hand warm water and a towel. In case of some remaining grease, use some
Isopropanol. Make sure the bed is completely cleaned and don’t touch the plate after cleaning.
We recommend using an adhesion product like spray (3DLac) or hairspray (make sure it’s sticky). In some cases,
using glue sticks (Elmer’s Washable School Glue) will work great too. Make sure you not to use too much of the
adhesion product as this will make the adhesion to the bed worse.
To Next Page
Loading...
