36
Operating the 3D printer
Click on the button Load Filament on the LCD screen or on your web interface.
Manually extrude a little bit to spool the filament completely through the nozzle. Click on the Extrude button and
select 50mm and 5mm/s.
Please don’t use more than 5mm/s for manual extrusion!
7.2 Unload material
Heat up the nozzle temperature to the printing temperature of the material which is inside your 3D printer at
this moment. Click on the nozzle icon on the LCD screen (it will become RED to show you it’s powered on).
Click on the active selection box below the nozzle to set the temperature (select temperature by clicking + until
desired temperature is reached and click SET afterwards). You can also use the web interface to set the nozzle
temperature. Wait for the nozzle temperature to reach the set temperature.
Click on the button Unload Filament on the LCD screen or on your web interface or do it manually.
To Next Page
Loading...
