2
Table of Contents
Disclaimer 4
Preface 5
1. Safety and compliance 6
1.1 Safety Notices 6
1.2 Hazards 6
2. Introduction 8
2.1 Main components 8
2.2 Specifications T850P 8
2.3 Specifications T650P 10
3. Unboxing 12
4. Setup for rst use 12
4.1 Set up network 12
4.2 Update the firmware 15
4.3 Calibrating the print bed 16
4.4 Installing slicing software 17
4.5 Uploading files to 3D printer 23
5. Operation 24
5.1 Web interface 24
5.2 Heated Chamber 29
6. Materials 30
6.1 Material compatibility 30
6.2 Print recommendations 31
6.3 Tips for experimental materials 32
7. Operating the 3D printer 34
7.1 Load material 34
7.2 Unload material 36
7.3 Removing the filament with a blob 37
To Next Page
Loading...
