Page 2 of 27 The AA Signs– Company Confidential
Version 1.0
Overview
The Signs division of The AA Ltd require Trakm8 to provide a telematics solution that will monitor, collate and stream data
including:
CANbus data to show fuel usage
Beacons– input zero to monitor when the beacons are operational
Green/red switch enclosure – input 1 and input 2 to monitor when sign(s) deployed and collected
GPS tracking
Driver Feedback
Please note that driver identification (dallas key) is no longer required on The AA Signs. Disconnect the driver id receiver from the
T8 premium wiring loom (2 molex connectors) but DO NOT remove it from the vehicle panel.
This document has been produced to provide exact instructions on how this equipment is to be installed, input location and
any interfaces have been agreed with The AA Ltd and under no circumstances should be deviated from without written
permission.
Please note that you are not insured to drive / move The AA Ltd vehicle during the installation process.
Ensure the ignition remains switched OFF at all times during the installation. Any connections made with power to the Trakm8
unit will cause faults on the vehicle ECU.
To Next Page
Loading...
