Trakm8 Install Ford Transit
Version 1.0
The AA Signs– Company Confidential
Page 27 of 27
Commissioning and Completion of Installation
• Before contacting Trakm8 to commission the unit start the engine. When the unit has powered up and 3 green trills (GPRS) and 3
green flashes (GPS) have been observed, operate the beacons and pushbuttons to generate an events.
• Please have the following information available for the Trakm8 commissioning team. This will make the process quicker if these
details are at hand:
Unit imei (this is the 15 digit serial number across the Trakm8 unit)
Vehicle registration
Odometer reading
• You will be asked to observe the Driver Feedback Display while the engine is idling. This is to confirm the LED status runs through
the GREEN-AMBER-RED status in the correct order.
• When Trakm8 have finished commissioning the unit and confirmed location, CANbus data, beacons switching high/low,
pushbutton (sign deployed and collected) events and idling is observed you will then be issued with a unique commissioning
number.
• The vehicle can now be rebuilt checking all panels are fitted correctly and all waterproof seals are in place. Please ensure that the
vehicle is left in a clean and tidy manner with all cable tie ends and cable snips removed from the vehicle.
A vehicle post installation check should now be completed to check vehicle functions.
To Previous Page
Loading...
