Trane Technologies MCW Series - Page 10

MS-SVU50A-TH10
Control
Sleep Mode
• Press SLEEP button to start
sleep mode.
• Press SLEEP button again to
cancel sleep mode.
Remarks
1. When select SLEEP MODE, the
icon will display.
2. Unable to use SLEEP MODE
when the air conditioner is
under FAN MODE or AUTO
MODE.
Sweep Mode
• Press SWEEP button to start
automatic cooling air distribu-
tion function.
• Louver will distribute the
cooling air by up and down
direction automatically.
• Press SWEEP button again to
turn off sweep mode.
Remarks In SWEEP mode, the icon
will display.
Dehumidication mode X-FAN
• Press X-FAN buttin before turn
on the air conditioner.
• When the air conditioner stops
operation, the fan will operate by
the minimum speed for 10
minutes to remove some water at
indoor unit’s heat exchanger.
• Or press X-FAN button to stop
fan operation immediately after
the air conditioner stops opera-
tion.
• Press X-FAN button again to
cancel dehumidication mode.
Remarks
1. When select X-FAN, the icon
will display on the remote
control.
2. Able to use X-FAN mode while
in COOL or DRY Mode only.
Turn Display Off at FCU
• Press LIGHT button to turn on/off
the temp. display at FCU.
Remarksุ When select to display
temp. at FCU, the icon will show
on the remote control.
I FEEL Function
• Press I FEEL button, the remote
control will scan the temp. around
the remote control handle and
send it to the FCU’s processor
every 10 minutes to provide the
most comfort room temp. to the
people in the room.
Remarksุ For the most effective way
of using I FEEL function, you should
always point the infrared sender of
the remote control direct to the
receiving window on the FCU.
Change of Temp. Display Unit
• Press MODE and - buttons
altogether while turn off the air
conditioner to change from
degree Celsius to Fahrenheit.
Button Locking of a Remote
Control
• Press + and - buttoms altogether
to lock/unlock the buttoms of a
remote control.
Remarks When lock buttons on a
remote control, the icon on a
remote control will display.