Trane Technologies MCW Series - Maintenance; General Maintenance Guidelines; Air Filter Cleaning Procedure; Front Panel Cleaning

MS-SVU50A-TH12
Maintenance
General Maintenance
Cut off the power source before
check or repair everytime.
1. Air Filter Cleaning
1.1 Remove the air lter by
pulling it down like the
picture shown below.
1.2 For maximum cooling
efciency with saving the
energy and providing
fresh air, the air lter
should be cleaned every 1
or 2 weeks.
1.3 Use non-PH clean water
or a vacuum cleaner to
clean the air lter.
1.4 Do NOT use the hot water
over 40°C or a volatile
substance e.g. gasoline or
thinner cleans the air
lter.
1.5 Dry the air lter until it is
dry prior insert it back to
the unit.
2. Front Panel Cleaning
Remove a front panel and
the body by following
Picture 1-3 for cleaning
(after cleaning, all parts
need to be assembled
before start the unit).
2.1 It can be cleaned very
often by rubbing the unit
with a soft and damp
towel.
2.2 In case the unit is very
dirty, a soft rubbing towel
dipped by some luke
water or a non-PH sub-
stance would be used to
clean the unit.
2.3 Do NOT use a soft towel
dipped with some hot
water > 40°C or a volatile
e.g. gasoline and thinner
to rub the unit in order to
prevent any damage
effected on the external
surface of the unit’s body.
2.4 Do NOT spray any pesti-
cide to the unit.
2.5 Do NOT clean by injection
some water directly to the
a unit.