WSHP-SVX014J-EN
35
Table 24. Zone sensor selection for use with Symbio™ 400-B/Tracer® UC400-B controller (continued)
Sensor Part Number
Description
X1379084501 Zone Sensor
• Symbio 400-B/UC400-B compatible
• External setpoint adjustment wheel
• ON and CANCEL buttons
• Fan switch AUTO-OFF
X1379044401 Temperature and relative humidity sensor
• Symbio 400-B/UC400-B compatible
X13790993001 Commercial Touch Screen Programmable Zone Sensor
• Supports Standby, Occupied, and Unoccupied
• 7 day, 5+2 day, and 5+1+1 day
• Cannot be used with BAS as sensor ties up BACnet link. For use with factory-
programmed Symbio 400-B/UC400-B.
Notes:
• Adjusting the rotary switch on Symbio 400-B/UC400-B may be
required to correspond address configuration in the sensor. See the
installation manual for more information.
• Additional configuration is needed in the field to use the Programmable
zone sensors (to put BAS points in service on Symbio 400-B/UC400-
B).
X13790992001 Residential Touch Screen Programmable Zone Sensor
• Supports Awake, Away, Home, and Sleep
• 7 day, 5+2 day, and 5+1+1 day
• Cannot be used with BAS as sensor ties up BACnet link. For use with factory-
programmed Symbio 400-B/UC400-B.
Notes:
• Adjusting the rotary switch on Symbio 400-B/UC400-B may be
required to correspond address configuration in the sensor. See the
installation manual for more information.
• Additional configuration is needed in the field to use the Programmable
zone sensors (to put BAS points in service on Symbio 400-B/UC400-
B).
Installation
To Next Page
Loading...
