page 24 850 User Guide
A Nexia registration button is located on the Menu screen of the XL850. After
the control is registered with Nexia the button may be used to add devices or
remove devices from a Z-Wave network.
Z-Wave Settings may be used to add or remove Z-Wave devices before
connecting the control (thermostat) to a local area Wi-Fi network and
registering the control with Nexia smart home.
An installer can now add all of the Z-Wave devices a customer has purchased
into the control’s Built in Nexia Bridge prior to connecting the control to the
homeowner’s local area network and registering the control with Nexia. All of
the Z-Wave devices will need to be installed in the home and congured with
Nexia smart home prior to use.
If the Z-Wave devices are added prior to connecting the control with the
homeowners local area network and then registered with Nexia, the Nexia
portal will recognize all of the pre-enrolled devices after registration is
complete, making enrollment easy and fast.
Nexia™ Registration
To Next Page
Loading...
