Trane ComfortLink XL850 - XL850 Z-Wave Device Management; Adding Z-Wave Devices to the Bridge; Removing Z-Wave Devices and Updating Network

032-5091-05 page 27
Adding/Removing Z-Wave Devices
(via XL 850)
To select Adding/Removing Z-Wave Devices press:
Home Screen > Menu > Nexia
Your XL850 is designed to integrate seamlessly with
a Nexia™ smart home system.
Adding Z-Wave Devices
1. From the HOME Screen, press MENU, then
press NEXIA.
2. Press ADD DEVICE and follow the device
manufacturer’s instructions for setting the
Z-Wave device into learn mode. You will have
four minutes to set the device into learn mode
after pressing the ADD DEVICE button.
Removing Z-Wave Devices
1. From the HOME Screen, press MENU, then
press NEXIA.
2. Press REMOVE DEVICE and follow the
manufacturer’s instructions for setting the
Z-Wave device into learn mode. You will have
four minutes to set the device into learn mode
after pressing the REMOVE DEVICE button.
Advanced Z-Wave Settings
Press ADVANCED for advanced Z-Wave functions
including unregistering your bridge from Nexia or
factory resetting your bridge. See the Advanced
Z-Wave Settings section for more information.
Update Network
Press UPDATE NETWORK to update the network
of your bridge. Updating the network can generate
a lot of Z-Wave trac over the network and can take
up to 15 minutes to complete.