032-5091-05 page 29
Advanced Z-Wave Settings
Nexia’s ADVANCED SETTINGS screen contains
three very powerful functions. Each of these
functions is very specic and should be approached
with a measure of caution. They cannot be “undone.”
Learn
To add the bridge to an existing network, follow
your primary controller’s instructions to put the
primary controller into Add Mode. Then press the
Learn button on the bridge.
This function copies a new Z-Wave network to the
bridge from another controller. This function is not
allowed if your bridge is a primary controller with
included Z-Wave devices.
Unregister
Removes the bridge from Nexia. All remote control
features will be disabled.
Factory Reset
Resets all Z-Wave information and removes all
devices from the bridge. If this bridge is the primary
controller for your network, resetting it will result
in all the devices in your network being removed.
Following the reset, it will be necessary to remove
and then add all of the devices back to your
network.
Bridge Information
If this bridge is being used as a secondary or
inclusion controller in the network, please reset this
bridge only in the event that the primary controller
is missing or otherwise inoperable.
Navigate to Advanced Z-Wave Settings Screen by pressing:
Home Screen > Menu > Nexia > Advanced
To Next Page
Loading...
