CG-SVX039C-GB
43
Schematic pump package
Installation – Mechanical
Chiller can be ordered with an optional integrated hydraulic module. In this case, chiller will be provided with the
following components factory mounted and tested:
• Centrifugal water pump, Low pressure or High pressure (option)
• Water strainer to protect the pump against impurities in the circuit
• Expansion module with expansion vessel and pressure relief valve sufficient to ensure the expansion of the water
loop ability
• Thermal insulation for antifreeze protection
• Balancing valve (optional) for equilibrate the flow of water circuit
• Drain valve
• Temperature sensor
Note: A pressure switch device to detect lack of water is not included in the pump package. Installation of this type of
device is highly recommended to avoid sealing damage due to operation of pump without enough water.
Pump package schematics is supplied in the documentation set shipped with the unit.
CGAF
To Next Page
Loading...
