This setting affects all time displayed in Photo Frame (alarm, system time, auto-on/off).
• Auto On at: Set a daily auto power-on time. Press LEFT or RIGHT to select hour or minute and
UP or DOWN to adjust the value.
• Auto Off at: Set a daily auto power-off time. Press LEFT or RIGHT to select hour or minute and
UP or DOWN to adjust the value.
• Auto On/Off timer: Press UP or DOWN to enable or disable the auto power on/off function.
3. After making adjustments, press to save.
Language
Use this function to change the interface language of Photo Frame (13 languages are currently available).
The default language is “English.” To change the Language:
1. Select the Language option from the Settings menu.
2. Use the LEFT or RIGHT buttons to highlight the desired language.
3. Press to confirm the new language setting. The new setting will be applied immediately.
Restore Defaults
This function is available if you want to reset your Photo Frame’s settings. Note: All settings that have been
changed will return to the factory defaults.
1. Select Restore defaults from the Settings menu.
2. Use the LEFT or RIGHT buttons to highlight “Yes.”
3. Press to confirm.
4. After the process is finished, the Settings menu will be displayed again.
Upgrade Firmware
Use this function to keep your Photo Frame up to date with the latest version from Transcend
(available on the Transcend website.
1. Insert a storage device such as a USB flash drive or SD/SDHC/MMC/MS/CF memory card that
contains a newer version of firmware.
2. Select Firmware upgrade from the Settings menu and press to start the firmware detection
process. Photo Frame will automatically find the new firmware file.
3. If Photo Frame finds that a newer version of firmware is available, a “Yes / No” selection message
will be shown. Press LEFT or RIGHT to select “Yes” and press to perform the system
upgrade. If you do not want to upgrade, press “No” to return to the Settings menu.
To Next Page
Loading...
