Travis Industries DVS GSR Insert - Steps for Finalizing the Installation

26 Finalizing the Installation
© Travis Industries 4090812 100-01232_001
Steps for Finalizing the Installation
1. Remove the glass (see page 20).
NOTE: If using propane (LP) convert the appliance prior to installing the logs.
2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to be detected
once it enters the firebox, ensuring gas does not build up.
3. Make sure the accent light bulb is in place.
NOTE: Take care to not touch the bulb with your fingers – use a cloth or paper towel).
4. Install the four AA batteries and receiver cover (included in the owner’s pack - see illustration below). The AA
batteries act as a power backup in case the household (AC) power goes out and are required for operation.
Install the 9v battery (included in the owner’s pack) into the battery holder (see illustration below). This battery is
for the control panel lights. Install three AAA batteries into the remote (see illustration below). Synchronize the
transmitter to the receiver (see page 28).
9v
Battery
Battery Holder for
Control Panel Lights
ACCENT LIGHT
OFF
HIGH
LOW
CONTINUOUS
PILOT
GREEN SMART
PILOT
ON
REMOTE
OFF
PRG
°F
AAA Battery
AAA Battery
AAA Battery
AA Battery
AA Battery
AA Battery
AA Battery
The remote receiver
uses 4 AA batteries.
The remote
uses 3 AAA
batteries.