38 Maintenance
© Travis Industries 4090812 100-01232_001
Maintaining Your Heater's Appearance
Fingerprints or other marks left on the optional plated surface may become etched in place if they are not
wiped clean prior to turning the heater on. Clean the plated surfaces with denatured alcohol and a soft
cloth (with the heater cool). Other cleaners may leave a film that may become etched into the surface.
Battery Replacement
Receiver Battery Installation
Install four AA batteries into the receiver (see illustration below). You can use the batteries from the
battery backup tray on the appliance. See the installation instructions for details. These batteries control
the comfort control and act as a power-backup in case the household (AC) current goes out.
Control Panel Light Battery
LED lights and a 9v battery are used to illuminate the control panel when the concealment cover is lifted. If the LED
lights do not operate, replace the 9v battery (see the illustration below). The battery holder is held in place with Velcro
and may be removed for easier access.
Transmitter Battery Installation
Install the three included AAA batteries into the remote (see illustration below).
9v
Battery
Battery Holder for
Control Panel Lights
ACCENT LIGHT
OFF
HIGH
LOW
CONTINUOUS
PILOT
GREEN SMART
PILOT
ON
REMOTE
OFF
PRG
°F
AAA Battery
AAA Battery
AAA Battery
AA Battery
AA Battery
AA Battery
AA Battery
The remote receiver
uses 4 AA batteries.
The remote
uses 3 AAA
batteries.
To Next Page
Loading...