Appendix E - Command Line Interface
Figure 70: CLI Port Settings
4. Use the “Connect” command to start the connection.
5. You will be prompted for a user name and password.
Enter the current user name and password for the AP you are connecting to.
The default values are admin for the User Name, and password for the Password.
6. You will then see the prompt, and can then use any of the commands listed in the follow-
ing Command Reference.
Command Reference
The following commands are available.
? Display CLI Command List
admin Temporary factory admin
config wlan config wlanX
config profile config profile
del acl Delete Access Control List
del key Delete Encryption key
find bss Find BSS
find channel Find Available Channel
find all Find All BSS
format Format flash filesytem
bootrom Update boot rom image
97
To Next Page
Loading...
Need help?
General
