Access Point Setup
Parameters
Disassociated Timeout
This determines how quickly a Wireless Station will be consid-
ered "Disassociated" with this AP, when no traffic is received.
Enter the desired time period.
Fragmentation
Enter the preferred setting between 256 and 2346. Normally,
this can be left at the default value.
Beacon Interval
Enter the preferred setting between 20 and 1000. Normally, this
can be left at the default value.
RTS/CTS Threshold
Enter the preferred setting between 256 and 2346. Normally,
this can be left at the default value.
Preamble Type
Select the desired option. The default is "Long". The "Short"
setting takes less time when used in a good environment.
Output Power Level
Select the desired power output. Higher levels will give a
greater range, but are also more likely to cause interference with
other devices.
Antenna Selection
If your Access Point has only 1 antenna, there is only 1 option
available. If your Access Point has 2 antennae, select the option
which gives the best results in your location.
802.11b
Protection Type
Select the desired option. The default is CTS-only.
Short Slot Time
Enable or disable this setting as required.
Protection Mode
The Protection system is intended to prevent older 802.11b
devices from interfering with 802.11g transmissions. (Older
802.11b devices may not be able to detect that a 802.11g
transmission is in progress.) Normally, this should be left at
"Auto".
Protection Rate
Select the desired option. The default is 11 Mbps.
41
To Next Page
Loading...
Need help?
General
