TEW-753DAP User’s Guide System Conguration
© Copyright 2013 TRENDnet. All rights reserved.
22
Spanning Tree
The TEW-753DAP is designed for end point access as well as backbone
connecon. To avoid network looping, you can enable 802.1d spanning
tree protocol�
Spanning Tree Status: Enable or disable 802.1d spanning tree
protocol to avoid network looping
Bridge Hello Time : The me between each bridge protocol
data unit (BPDU). Default: 2 sec.
Bridge Max Age : Maximum me a BPDU kept in bridge.
Default: 20 sec.
Bridge Forward Delay : The me to be spent in listen and learning
state. Default: 4 sec.
Priority : Priority number for root bridge selecon.
(MAC number is listed on Status > Main
page)
Apply : Click this buon to apply the change
Cancel : Click this buon to cancel the change
Band Steer
In the oce, the 2.4GHz is always crowded than 5GHz. There are fewer
non-overlapping channels and more legacy devices in 2.4GHz compare
to the 5GHz band. The TEW-753DAP is equipped with 2.4GHz and 5GHz
wireless interfaces. When your client device can work on both 2.4GHz
and 5GHz wireless, Band Steer will choose 5GHz as primary band over
2.4GHz. Trac will mainly stays on 5GHz in stead of 2.4GHz. To setup
band steer, you have to setup the same SSIDs on both the 2.4GHz and
the 5GHz interfaces. Then check Enable on this page. Then click Save�
Save : Click this buon to save the change.
(Save/Apply is required to apply changes.)
Cancel : Click this buon to cancel the change
To Next Page
Loading...
Need help?
General
