2. Click on the Management tab and click SNMP Settings.
3. Review the settings and click Save to save settings.
• SNMP: Select enable to enable SNMP feature
• Contact: Enter the contact person or contact information for your access point.
• Location: Enter an assigned location for your access point.
• Community Name (Read only): Enter an assigned name for your access point.
• Community (Read/Write): Enter a public and private community name.
• Trap Destination Address: Enter the destination IP address of the SNMP trap.
• Trap Destination Community Name: Enter the name of the destination community
• SNMPv3: Select option to enable or disable SNMPv3
• Username: Enter the username
• Auth Protocol: Select from the pull down menu the authentication protocol to use
• Auth Key: Enter the authentication key
• Priv Protocol: Select the private protocol
• Priv Key: Enter the private key
• Engine ID: Enter the engine name
4. Click on Apply button to apply the settings and then click on the Save button located
on the top right section to save the settings.
SSH Management
Management > SSH Management
SSH (Secure SHell) is a form of a CLI (Command Line Interface), a user interface where
commands can be sent to the access point in the form of successive lines of text
(command lines).
1. Log into your management page (see “Access the management page” on page 16).
2. Click on the Management tab and click SSH Management.
3. Select Enable and click Save to save settings.
4. Click on Apply button to apply the settings and then click on the Save button located
on the top right section to save the settings.
To Next Page
Loading...
Need help?
General
