5. Configure the below settings and click Save to save settings.
• Wireless Mode: Select the wireless mode to set on the selected wireless band in
client bridge mode
• SSID: Manually enter the wireless network name (SSID) you want to establish
connection. Or simply click on Site Survey to scan for available wireless network
(more on this function in below section).
• Preferred BSSID: Click option and enter the MAC address of the preferred wireless
network you would like to connect to.
• Repeater SSID: You may specify a new SSID name to use
• Security Mode: Select from the pull-down menu the wireless security that is used
on the wireless network you would like to connect to.
6. Click on Apply button to apply the settings and then click on the Save button located
on the top right section to save the settings.
Scan for wireless networks
Wireless (2.4GHz or 5GHz) > Wireless Network
This section outlines the available features to configure for both wireless 2.4Ghz and
5GHz when Repeater mode is selected.
1. Log into your management page (see “Access the management page” on page 16).
2. Click on the wireless band you would like to configure and click Wireless Network.
3. Under SSID section click Site Survey to wireless scan for available wireless networks.
4. Click on the wireless network you would like to repeat. The information will
automatically fill on the previous screen. You will then need to select and enter the
wireless security.
To Next Page
Loading...
Need help?
General
