Ltd is absolved from any civil or criminal responsibility.
Adhesives sealants and paints used in the manufacture of
the product are cured and present no hazards when used in
the manner for which they were intended. The appliance
contains no asbestos.
2.3 Operating Warnings
Shut the appliance down in the event of a breakdown or bad
running.
Pellets must not be fed manually into the burner.
Accumulated un-burnt pellets in the burner after repeated
filed ignitions must be removed before re-lighting.
Do not wash the inside of the heat exchanger with water.
Do not wash the appliance with water. The water could get
into the unit and damage the electrical installation and cause
electric shocks.
Do not put any fuel, other than wood pellets, in the hopper.
Install the appliance in a location which is suitable for fire
fighting, and equipped with all services such as air and
electricity supply and provision for discharging combustion
gases.
If there is a fire in the flue pipe, extinguish the appliance,
disconnect it from the power supply and never open the
door. Then contact the competent authorities.
If the appliance is in storage, it should be in a place that is
free of damp, and it should not be exposed to extremes of
temperature.
It is inadvisable to base the appliance directly on a floor (if
located indoors), and if the floor is made of flammable
material, it must be suitably insulated.
Do not light the appliance with flammable materials if the
ignition system breaks down.
2.4 Guarantee and Warranty Information
In case of any problems, get in touch with your dealer, or a
qualified engineer authorised by T R Engineering Ltd, and if a
repair is necessary, insist on the use of original spare parts.
Use only the fuel recommended by T R Engineering Ltd
(Enplus-A1) may be used with this appliance.
Periodically check and clean the smoke outlet ducts
(connection to the flue pipe).
Accumulated un-burnt pellets in the burner after repeated
failed ignitions must be removed before lighting.
Always keep the cover of the fuel hopper closed.
Keep this instruction manual carefully because it must stay
with the appliance throughout its working life. If the
appliance is sold or transferred to another user, always make
sure that the booklet goes with the product.
If it gets lost, ask T R Engineering Ltd or your authorised
dealer for another copy.
Guarantee Conditions
T R Engineering Ltd offers the following warranties on this
appliance:
Leaks in the heat exchanger – 5 years
Faulty electrical components (motors, fan, controller) – 1
year
Pump, Ignition Element – 1 year.
From the date of first ignition of the appliance as proved by a
valid commissioning report which gives the name of the
installer/commissioning engineer and the date on which the
commissioning took place. The guarantee is conditional on
the commissioning report being filled in and returned to the
manufacturer within 10 days, and requires that the product
be installed and commissioned by an approved T R
Engineering installer according to the detailed instructions
given in the instruction booklet supplied with the product.
The term ‘guarantee’ is to be understood to denote the free
of charge replacement or repair of parts recognised to have
been defective at the start by reason of manufacturing
defects.
2.5 Limitations
The above guarantee does not cover parts subject to normal
wear such as gaskets, fibre board on doors and parts which
can be removed from the firebox such as burner pot, baffles
and ash box. The replacement parts will be guaranteed for
the remainder of the guarantee period starting from the date
of commissioning of the product.
To Next Page
Loading...
