Seeker D User’s Guide
Document Num., Rev. 4May 2018 Page 33
About the Battery of Your Seeker D
The Seeker D uses Lithium-Ion batteries. The batteries are charged during manufacture and
should be ready to use as long as it has not been stored for a long period of time.
Lithium-Ion batteries operate differently than Nickel-Cadmium batteries. They should be
charged daily, and should not be deeply discharged as this could damage the battery. There is
no memory effect and concerns about charging too soon or with little use are unwarranted.
USB Charging
You can charge the Seeker D outside of the Mobile Mount using either of the following USB
charging methods:
• Connecting the Mini-USB cable and charger from an AC power source to the Seeker
D. The Mini-USB charge / data cable and charger must be connected to both the
Seeker D and a working power outlet before AC charging can begin.
• Connecting the Mini-USB charge / data cable from a PC or laptop computer to the
Seeker D. The Mini-USB charge / data cable must be connected to both the Seeker
D and a PC or laptop computer that is ON before USB charging can begin.
The following conditions apply when charging the Seeker D via USB:
• When the Seeker D is off and it is charging, the device will go into background
charging and nothing will be shown on the display screen.
• If the Seeker D is on when it is connected to a to a PC, laptop computer, or working
power outlet, the device will automatically turn off.
• If the Seeker D is turned back on when USB charging, the Measurement mode is
disabled while the Seeker D is USB charging.
• When the Seeker D is on and is charging, the screen
shown in the image to the right will be displayed, the
Charge icon will ash, and the on-screen bar graph will
show the charging progress.
To Next Page
Loading...
