Seeker D User’s Guide
Document Num., Rev. 4May 2018 Page 55
Seeker MCA III Display Screens (Optional)
GPS Signal
When the Seeker D is placed in the Mobile Mount, the GPS icon
is used to display the status of the GPS Signal as follows:
• When the GPS receiver is receiving a satellite signal, the
GPS icon will be displayed constantly.
• When the GPS receiver is not receiving a satellite signal,
the GPS icon will ash.
GPS Signal
When the GPS receiver has been off or has not been able
to receive a satellite signal, for more than ve minutes, the
device will beep twice every few seconds until the condition is
corrected.
When the Mobile Mount is not connected to a Seeker MCA III,
the GPS icon is not shown on the display.
When the GPS receiver IS NOT receiving a satellite signal, the
MCA III will not record leakage data from the Seeker.
To Next Page
Loading...
