TRIMAX SNAKE S2 OPERATORS MANUAL
ENGLISH EDITION
©Trimax Mowing Systems (NZ) Ltd
www.trimaxmowers.com 27 27 March 2019
10. Connect the mower to the tractor.
NOTE: If the tractor is fitted with a powered hitch, see the tractor operator’s manual for instructions.
a. The three-point linkage arms are not needed. Raise them to maximum height. Tie them together to
prevent tyre contact.
b. Use the screw jack on the mower to adjust the tow hitch
height to match the tractor drawbar.
c. Ensure any bystanders are well clear.
d. Reverse the tractor up to the mower until the drawbar is
aligned with the mower tow hitch.
e. Ensure all tractor controls are in neutral, apply the parking
brake and stop the tractor engine before dismounting.
f. Fit the drawbar pin.
g. Fit the retaining lynch pin or locking device to retain the
drawbar pin.
h. Wind the jack clear of the ground.
i. Swing jack into the storage position
11. Attach the breakaway safety chains (if fitted):
a. Connect the breakaway safety chains as described above.
b. Ensure the D-shackles are tightened securely.
IMPORTANT! Ensure the front of the mower chassis is the same height as
the rear. If the chassis is not level, mower deck movement may be restricted
and damage could result that may not be covered by warranty.
To Next Page
Loading...
Need help?
General