TRIMAX SNAKE S2 OPERATORS MANUAL
ENGLISH EDITION
©Trimax Mowing Systems (NZ) Ltd
www.trimaxmowers.com 56 27 March 2019
b. Every 40 hours or weekly, grease the
universal joints at either end of the driveshaft (a).
Pump until grease starts to exit the seals (b).
NOTE: Instructions for greasing the constant velocity (CV) joint on the primary driveshaft
follow below.
c. Every 40 hours or weekly, grease the safety
cover slipper bearings. Apply 2 pumps to each
slipper bearing.
a. Every 40 hours or weekly, pull the two
halves of the driveshaft apart.
b. Apply a liberal coating of grease inside
the larger tube (a) and on the outside of
the visible part of the smaller tube (b).
c. Re-assemble the two halves. Ensure
they telescope smoothly.
d. Oil the quick-release coupling pin and
sliding collars.
To Next Page
Loading...