TRIMAX SNAKE S2 OPERATORS MANUAL
ENGLISH EDITION
©Trimax Mowing Systems (NZ) Ltd
www.trimaxmowers.com 57 27 March 2019
3. Grease the primary driveshaft CV joint:
a. The CV joint has two universal joints coupled together with an enclosed disc between. The
disc has two grease points.
b. Holes in the safety shield allow access to these.
c. Every 40 hours or weekly, rotate the cover until the
grease points are visible.
d. Apply 1 shot or 4 pumps to each grease fitting.
e. The rear grease point for the enclosed disc is
accessible through the largest cut out in the tube end of
the safety shield when the safety shield holes are
aligned with the universal joint grease points.
f. Every 40 hours or weekly, apply 1 shot or 4 pumps to
the grease fitting.
g. The other grease point for the disc is accessible through
the safety shield hole nearest the coupling. Rotate the safety
shield about 10 degrees until it becomes visible.
h. Every 40 hours or weekly, apply 1 shot or 4 pumps to
the grease fitting.
To Next Page
Loading...