Trimax SnakeS2 User Manual

TRIMAX SNAKE S2 OPERATORS MANUAL
ENGLISH EDITION
©Trimax Mowing Systems (NZ) Ltd
www.trimaxmowers.com 65 27 March 2019
Cutting too much at
once
Run PTO at 540rpm, vary transmission to
travel more slowly
Raise cutting height for first cut, lower cutting
height & cut again in opposite direction
Excessive wheel marks
or poor
cutting finish
PTO speed too slow
Run PTO at 540rpm
PTO speed too fast
Run PTO at 540rpm
Cutting height too high
Lower cutting height
Excessive ground
speed
Run PTO at 540rpm, use transmission to
travel more slowly
Blades missing,
damaged or worn out
Replace blades
Ground too wet
Wait for ground to dry out
Cutting too much at
once
Raise cutting height for first cut, lower cutting
height and cut again in opposite direction
Lush grass sticking to
underside of mower
Try running PTO at 450rpm, use transmission
to maintain ground speed
Some long grass left
un-cut
Blades missing,
damaged or worn out
Replace blades
Debris trapped under
mower
Clear debris
Mower dirty
Wash grass from cutting chambers after use
Excessive clumping or
clippings build up over
rear roller
Steel anti-droop under
rubber flap bent,
blocking exit path
Straighten steel anti-droop strip
Mower scalps
excessively
Cutting too low
Raise cutting height
Fit optional Anti Wear Skids (AWS)
Mower decks do not
follow contours
Auxiliary hydraulic valve
not in float position
Use correct auxiliary hydraulic circuit. Set
valve to float position
No float position
available
Hold hydraulic lever in down position while
mower decks traverse dips
Mower deck skids mark
turf
Ground contours too
extreme for mower
Change mowing pattern to approach contours
from different angle
Wear skids too low
Adjust wear skids
Blades leave scalloped
pattern on turf
Travel speed too fast
Select a lower gear, travel more slowly
Mower decks bouncing
Fit optional wear skids

Trimax SnakeS2 Specifications

General

Brand	Trimax
Model	SnakeS2
Category	Measuring Instruments
Language	English