Notice to Australian Purchasers
The Australian Consumer Law
Ourgoods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement orrefund
fora major failure and forcompensation for any other reasonably
foreseeable loss ordamage. You are also entitled to have the goods
repaired orreplaced if the goods fail tobe of acceptable quality and the
failure does notamount to a majorfailure.
Trimble's warranty, as set outin the usermanual accompanying this
statement, oras described in the warranty card accompanying the
Product you purchased, is in addition to any mandatory rights and
remedies that you may have under the Australian ConsumerLaw.
Official Language
THE OFFICIAL LANGUAGE OF THESE TERMS AND CONDITIONS IS
ENGLISH. IN THE EVENT OF A CONFLICT BETWEEN ENGLISH AND
OTHER LANGUAGE VERSIONS, THE ENGLISH LANGUAGE SHALL
CONTROL.
Notices
COCOM limits
The U.S. Department of Commerce requires that allexportable GPS
products contain performance limitations so that they cannot be used in
a manner that could threaten the security of the United States. The
following limitations are implemented on this product:
– Immediate access to satellite measurements and navigation results is
disabled when the receiver velocity is computed to be greater than
1,000 knots, or its altitude is computed to be above 18,000 meters. The
receiver GPS subsystem resets until the COCOM situation clears. As a
result,all logging and stream configurations stop untilthe GPS
subsystem is cleared.
Class B statement- Notice to users
This equipment has been tested and found to comply with the limits for
a Class B digital device pursuant to Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may notcause
harmful interference, and (2) this device must accept any interference
received,including interference that may cause undesired operation.
This equipment generates, uses, and can radiate radiofrequency energy
and,if notinstalled and used in accordance with the instructions may
cause harmful interference to radio communication.
However,there is no guarantee that interference will notoccur in a
particularinstallation. If this equipmentdoes cause harmful interference
to radioortelevision reception, which can be determined by turning the
equipment off and on,the user is encouraged to try to correct the
interference by one ormore of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipmentand the receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealeroran experienced radio/TV technician forhelp.
Changes and modifications notexpressly approved by the manufacturer
orregistrant of this equipment can void your authority tooperate this
equipment under Federal Communications Commission rules.
The radios in this device have been designed and manufactured to not
exceed stipulated emission limits forexposure to radio frequency (RF)
energy as required by the Federal Communications Commission of the
U.S. Government47 C.F.R. § 2.1091 and 2.1093.
The external antenna connector provided in this device is for GNSS
antennas only.
Canada
This digital apparatus does not exceed the Class B limits forradio noise
emissions from digital apparatus as set out in the radio interference
regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émetpas de bruits radioélectriques
dépassantles limites applicables aux appareils numériques de Classe B
prescrites dans le règlement surle brouillage radioélectrique édicté par
le Ministère des Communications du Canada.
Antenna Statement
Under Industry Canada regulations,this radiotransmitter may only
operate using an antenna of a type and maximum (orlesser) gain
approved for the transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and its gain should be
so chosen that the equivalent isotropically radiated power(e.i.r.p.) is not
more than that necessary forsuccessful communication.
Conformémentà la réglementation d'Industrie Canada, le présent
émetteur radio peutfonctionner avec une antenne d'un type et d'un
gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie
Canada. Dans le but de réduire les risques de brouillage radioélectrique à
l'intention des autres utilisateurs,il fautchoisir le type d'antenne et son
gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.)
ne dépasse pas l'intensité nécessaire à l'établissementd'une
communication satisfaisante.
Licence exempt
This device complies with Industry Canada licence-exemptRSS standard
(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference,including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes :
(1) l'appareil ne doitpas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter toutbrouillage radioélectrique
subi,même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Europe
This product has been tested and found tocomply
with all requirements forCE Marking and sale within
the European Economic Area (EEA). It is classified
and marked as being Class 2 RadioEquipmentunder
2000/299/EC, as Bluetooth and wireless LAN
approvals are country specific. Please consultyour local distributorfor
more information.
EU – Restrictions for Use in the 2.4GHz band
This device may be operated indoors oroutdoors in all countries of the
European Community using the 2.4GHz band, except where noted
below.
–In Norway, this unit may not be operated within 20 km of Ny Alesund
This GNSSreceiver has Bluetooth approval in most EU countries and
satisfies the requirements forRadioand Telecommunication Terminal
Equipment specified by European Council Directive 1999/5/EC. These
requirements provide reasonable protection against harmful
interference when the equipment is operated appropriately in a
residential orcommercial environment.
A copy of the CE Declaration of Conformity can be accessed from
http://www.trimble.com/support.shtml.
Australia and New Zealand
This product conforms with the regulatory requirements of
the Australian Communications and Media Authority
(ACMA) EMC framework, thus satisfying the
requirements forC-Tick Marking and sale within Australia
and New Zealand.
Japan
This device has been granted two designation numbers by Ministry of
Internal Affairs and Communications: according:
Ordinance concerning Technical Regulations Conformity Certification etc.
of Specified Radio Equipment (特 定無線 設備 の技術 基準 適合証 明
等に関する規則 )
Article 2 clause 1 item 19
Approval no: 007-AC0223
This device should not be modified (otherwise the granted designation
numbers will be invalid).
Restriction of Use of Certain Hazardous Substances in Electrical
and Electronic Equipment (RoHS)
Trimble products in this guide are in compliance in all material respects
with DIRECTIVE 2011/65/EU OF THE EUROPEAN PARLIAMENT AND OF
THE COUNCIL of 8 June 2011 on the restriction of the use of certain
hazardous substances in electrical and electronic equipment (recast).
This certification is limited to Productplaced on the market in the
MemberStates of the European Union on or after 1-January-2013.
Trimble R1 GNSS Receiver User Guide 3
To Next Page
Loading...
Need help?
General
